Drying your filament is always good practice if you're going to 3D print something, and eSun provides an inexpensive little dry box called eBox Lite.

However, I was not a huge fan of the large tube that comes with the kit, and wanted to use regular PTFE tubes instead, so I made this little adapter where you can push a regular 4.5mm PTFE tube, and also use a PC4-M10 adapter to keep things secured.

This should also be compatible with the regular eBox.

OBS.: The PC4-M10 is a nice-to-have. It'll ensure your PTFE tube will stay in place in the long run, but it's also possible to directly insert the PFTE tube into this adapter.

Do you like my models? Consider buying me a coffee ;)

Required parts

1x PC4-M10 Pneumatic PTFE Tube Connector
1x PTFE tube (4.5mm outer diameter)

Print Settings

Supports:

Yes. Use support materials if possible.

Resolution:

0.12

Walls/Perimeters:

2 or 3.

Wall generator:

Arachne.

Infill:

100%.

Filament:

PETG/ABS/ASA/PC/Nylon

(If you're only drying PLA, you can also print this in PLA)