If you want to sell prints of this model, as well as all of my models - future and past
Subscribe to

My Patreon

A beautiful set of bookmarks in the traditional style of “Under the Wave off Kanagawa” with built in holes for tassels.

Maker notes:

While the included profiles are carefully optimized for a 0.4 mm nozzle to retain detail across different settings, this model is still best printed with a 0.2 mm nozzle for the sharpest ribs, phalanges, and frame curls 🧩🖨️
Make sure to clean the build plate with dishwashing soap and warm water before printing. Handwashing soaps should never be used to clean build plates because moisturizers can harm adhesion 🧼💧

USE A LIGHTER! - a quick pass with a torch on the printed parts will get rid of the inevitable stringing that comes with this type of models.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used in the photos:

PLA Kingroon Black Transmission Distance: 0.4

PLA KINGROON Blue Transmission Distance: 4

PLA+ Jayo Mint Green Transmission Distance: 4.5

PLA+ Jayo Sky Blue Transmission Distance: 4.4

PLA Jayo Matte White Transmission Distance: 4.6 (There is a pause at the end of the Sky Blue color. You have to unload it and load White on the same slot. Then resume printing normally)

PLA EryOne Rose Red Transmission Distance: 2.4(There is a pause at the end of the White color. You have to unload it and load RED on the same slot. Then resume printing normally)

Color Palette:

Swap Instructions:

Start with Black
At layer #6 (0.56mm) swap to Blue
At layer #9 (0.8mm) swap to Mint Green
At layer #11 (0.96mm) swap to Sky Blue
At layer #12 (1.04mm) swap to White (There is a pause at the end of the Sky Blue color. You have to unload it and load White on the same slot. Then resume printing normally)
At layer #16 (1.36mm) swap to Rose Red for the rest. (There is a pause at the end of the White color. You have to unload it and load RED on the same slot. Then resume printing normally)