Print-in-place articulated Tiny Owl!

My smallest design up today 😁
Keychain version included!

Considerations:

It's small and articulated. That means that good bed adhesion is required. For tricky filaments that usually have worse adhesion I recommend using some kind of glue (my personal favourite is 3DLac spray).
Because of its size, I recommend printing them at 0.16 mm layer height. 0.2 mm should work as well.
It has a small built-in brim for the wings. Easy to remove after printing.
It has a couple of support dots in the armpits to help stabilize the wings during printing. It may feel a bit hard to open the wings on the first try, but should be loose after that.
To change colors easily, check my quick tutorial.